|Dimensions||190.7mm x 115.7mm x 11.7mm|
|Website||Device Product Page|
|SoC||A33 @ 1.3Ghz|
|DRAM||512MiB DDR3 @ 400MHz|
|Power||DC 5V @ 1A, 2000mAh 3.7V Li-Ion battery|
|LCD||1024x600 (7" 16:9)|
|Touchscreen||X-finger capacitive/resistive (Manufacturer device)|
|Audio||3.5mm headphone plug, 3.5mm microphone plug, internal mono speaker, internal microphone|
|Network||WiFi 802.11 b/g/n|
|USB||1 USB2.0 OTG|
|Camera||??.?MP (????x????) front, ??.?MP (????x????) rear|
A Q8 style cheap tablet, but with an A33 SoC.
- 1 Identification
- 2 Sunxi support
- 3 Tips, Tricks, Caveats
- 4 Adding a serial port (voids warranty)
- 5 Pictures
- 6 Schematic
- 7 Also known as
- 8 See also
This section explains how to most easily identify your device. For a development board, explain the name(s) printed on the board. For an android device, find out the strings as reported under settings.
On the back of the device, the following is printed:
Tablet PC I T74ER
The PCB has the following silkscreened on it:
In android, under Settings->About Tablet, you will find:
- Model Number: DEVICE
- Build Number: Oysters_T74ER_SA002_08092015
Mainline U-boot OK from SD.
Mainline kernel started but usb and drm don't work
Use the q8_a33_tablet_1024x600_defconfig build target.
Only useful for A10/A10s/A13 and A20 based devices. Remove this section otherwise.
Use the MANUFACTURER_DEVICE.fex file.
Use the FAMILY-CHIP-DEVICE.dtb device-tree binary.
Tips, Tricks, Caveats
Add MANUFACTURER DEVICE specific tips, tricks, Caveats and nice to have changes here.
The Volume+ button triggers FEL mode.
Device specific topic
If there are no further device specific topics to add, remove these sections.
Adding a serial port (voids warranty)
This section explains how to attach a serial port to the device. Make sure it refers to our UART howto. For a development board, you can just mention how to find the header with the pins and include a picture, and you can remove the warranty voiding warning.
If necessary, provide a short description of how to open the device. Perhaps explain how the pins can be most easily popped. If pins do need to be popped, mention the Plastic tool howto.
Locating the UART
Describe how to find the RX,TX,GND signals here, and mention the UART howto.
Take some pictures of your device, upload them, and add them here. DO NOT UPLOAD PICTURES WHICH YOU PLUCKED OFF THE INTERNET.
List schematics, board layout, cad files, etc here.
Also known as
List rebadged devices here.
Add some nice to have links here. This includes related devices, and external links.
Optional. Add non-sunxi images in this section.