Trio Stealth Pro
|Trio Stealth Pro|
|Dimensions||widthmm x breadthmm x heightmm|
|Release Date||Month year|
|SoC||A10 @ 1Ghz|
|DRAM||1GB DDR3 @ xxxMHz|
|Power||DC 5V @ 1.5A, 2800mAh 3.7V Li-Ion battery|
|Touchscreen||X-Finger Capacitive (FocalTech FT5x06)|
|Video||HDMI (Type C - mini)|
|Audio||3.5mm headphone plug, HDMI|
|Network||WiFi 802.11 b/g/n (Realtek RTL8188???)|
|USB||1 USB2.0 OTG|
|Camera||0.3MP (640x480) front, 0.3MP (640x480) rear|
In android, under Settings->About Tablet, you will find:
- Model Number: TRIO-97C
- Build Number: crane_cube-eng 4.0.4 IMM76D 20130515
- For building u-boot, use the "MANUFACTURER_DEVICE" target.
- The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex
Everything else is the same as the Manual build howto.
Tips, Tricks, Caveats
The something button triggers FEL mode.
Adding a serial port (voids warranty)
The device is easily disassembled by sliding your plastic tool between the metal back plate and the black plastic ring around the edge of the device.
Locating the UART
The UART0 RX/TX pins are identified in the picture to the right. The red arrow points to UART0_TX and the blue arrow points to UART0_RX. These pads are located on the back side of the PCB.