T702A

From linux-sunxi.org
Jump to: navigation, search
T702A
T702a front.jpg
Manufacturer Unknown.
Dimensions 192mm x 122mm x 12mm
Release Date March 2012
Website Unknown.
Specifications
SoC A10 @ 1Ghz
DRAM 512MiB DDR3 @ 360MHz
NAND 4GB
Power DC 5V @ 2A, ?mAh 3.7V Li-Ion battery
Features
LCD 800x480 (7" 16:9)
Touchscreen 5-finger capacitive/resistive (Focaltech FT5206GE1)
Video HDMI (Type C - mini)
Audio 3.5mm headphone plug, 3.5mm microphone plug, HDMI, internal speaker
Network WiFi 802.11 b/g/n (Realtek RTL8188CTV)
Storage µSD
USB 1 USB2.0 OTG
Camera 0.3MP (640x480) front

This Tablet is an A10 MID style device with capacitive buttons on the front, metal back cover, the typical 4 screws and the slot for the internal speaker on the connector side.

Contents

Identification

There is no printing on the case.

The PCB has the following silkscreened on it:

T702A_V02
2012/02/8

In android, under Settings->About Tablet, you will find:

  • Model Number: T02A
  • Build Number: crane_evb_v13-eng 4.0.3 IML74K 20120423 test-keys

Sunxi support

Current status

Supported.

Images

HW-Pack

BSP

Manual build

  • For building u-boot, use the T702A target.
  • The .fex file can be found in sunxi-boards as t702a.fex

Everything else is the same as the manual build howto.

Tips, Tricks, Caveats

FEL mode

The VOL+ button triggers FEL mode.

Adding a serial port (voids warranty)

UART pads

Device disassembly

Remove the 4 screws. Now gently push your Plastic tool between the plastic outer edge and the metal back cover. Try to go around the whole board until you hear some clips pop, and do this until all clips have released. Be careful when opening the device, as the Wifi antenna is taped to the back cover.

Locating the UART

On the back of the board, right next to the (back of the) SoC, there are two pads. All you need to do is solder on some thin wires according to our UART howto.

Pictures

Also known as

See also

Manufacturer images

Personal tools
Namespaces

Variants
Actions
Navigation
Tools