|Dimensions||182mm x 121mm x 7mm|
|Release Date||September 2013 (for the Mobii 2013)|
|Website||See AKA section|
|SoC||A13 @ 1Ghz|
|DRAM||512MiB DDR3 @ 360MHz|
|Power||DC 5V @ 1.5A, 2400mAh 3.7V Li-Ion battery|
|LCD||800x480 (7" 16:9)|
|Touchscreen||5-finger capacitive (Silead GSL1680)|
|Audio||3.5mm headphone plug, built-in microphone.|
|Network||WiFi 802.11 b/g/n (Realtek RTL8188ETV)|
|USB||1 USB2.0 OTG|
|Camera||640x480 (VGA) front-facing, Optional rear-facing camera|
This motherboard seems to have been used in several rebadges, and will come with different batteries, different cameras, and perhaps different Wifi modules and last but not last, this form factor is used in A23 and A33 tablet.
The back of the PCB reads Q8-V12., but google reveals that there are highly similar PCBs where a different name is silkscreened on the backside.
For the Point Of View Mobii 703, you will find, in android, under Settings->About Tablet:
- Model Number: POV_TAB_P703(V1.0)
- Build Number: nuclear_evb-eng 4.1.1 JRO03C 201311126 test-keys
The Build string is not helpful, as "nuclear_evb" just means A13 evaluation board.
To properly identify this device, open up the case, detach the motherboard, and look at the printing on the other side.
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
Use the POV_TAB_P703 build target.
Use the pov_tab_p703.fex file.
Tips, Tricks, Caveats
The Volume+ button triggers FEL mode.
Adding a serial port (voids warranty)
Locating the UART
On the back of the mainboard, there are two test pads near the SoC. Solder on some wires according to our UART howto.
- Point Of View Mobii 703 (Board is labelled Q8-V12)