|Dimensions||267mm x 164mm x 14mm|
|Release Date||Month year|
|Website||Out of print|
|SoC||A10 @ 1Ghz|
|DRAM||1GiB DDR3 @ xxxMHz|
|Power||DC 5V @ 3A, 6000mAh 3.7V Li-Ion battery|
|LCD||1024x600 (10" 10:6)|
|Touchscreen||5-finger capacitive (2x Focaltech FT5x)|
|Video||HDMI (Type C - mini)|
|Audio||3.5mm headphone plug, HDMI, internal speaker, internal microphone|
|Network||WiFi 802.11 b/g/n (Realtek 8192CU), in later models (Realtek 8188EU)|
|Storage||µSD, also an internal filled mmc slot|
|USB||1 USB2.0 Host, 1 USB2.0 OTG|
|Camera||0.3MP (640x480) front|
This device was imported and rebranded under the PengPod 1000 name by Peacock Imports, who was secretive about where they had bought them.
Although it comes in the same case as Inet_1, the board differs slightly.
- 1 Identification
- 2 Sunxi support
- 3 Tips, Tricks, Caveats
- 4 Adding a serial port (voids warranty)
- 5 Pictures
- 6 Also known as
- 7 See also
Apart from the names and symbols explaining the buttons, the back of the device is blank. It came with a small sticker proclaiming "N500c", indicating that it _may_ have been a Wayestar device.
The following is silkscreened on the underside of the PCB:
USEN 1252.040 (or some other numbers) YONESTOPTECH-1077 2012/05/05
In android, under Settings->About Tablet, you will find:
- Model Number: BC1077
- Kernel Version: 3.0.8+ [email protected] #50 Mon Nov5 09:51:29 CST 2012
- Build Number: crane_bc1077-eng 4.0.4 IMM76D 20121108 test-keys
Add MANUFACTURER DEVICE specific sunxi ROM images here. E.g. a livesuit image or some other linux image which uses linux-sunxi code. Do not put non-sunxi images here, they should live under See also. If no sunxi based images are available, this section can be left blank.
- For building U-Boot, use the MANUFACTURER_DEVICE target.
- The .fex file can (not yet) be found in sunxi-boards
- It can be found at this temporary location
Everything else is the same as the manual build howto.
Tips, Tricks, Caveats
It may need the same changes to fully support FT5X as mentioned on the Inet_1 page.
There is a button between power connector and Mini USB connector which supposedly triggers FEL mode.
Adding a serial port (voids warranty)
By removing the two screws on the connector side, the device is trivially opened.
Locating the UART
There are some marked UART pads in a corner of the board, near the type-A usb socket, where you'd need to solder on some wires according to our UART howto.
Also known as
List rebadged devices here.
Add some nice to have links here. This includes related devices, and external links.
Optional. Add non-sunxi images in this section.