|SoC||A64 @ 1.2GHz|
|DRAM||1GiB DDR3L @ 672MHz|
|NAND||4GB eMMC (optional)|
|Power||DC 5V (2.1/5.5mm barrel plug, centre positive), 3.7V Li-Po battery|
|Video||HDMI (Type A - full)|
|Audio||3.5mm headphone plug, 3.5mm microphone plug|
|Network||WiFi 802.11 b/g/n (Realtek RTL8732BS)|
|Storage||µSD, optional SPI NOR Flash on board|
|USB||1 USB2.0 Host, 1 USB2.0 OTG|
The PCB has the following silkscreened on it:
A64-OLinuXino Rev.D (c) 2017
The device can be booted by building apritzel's sunxi64-beta branch using the pine64_plus_defconfig.
You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.
Use the a64-olinuxino_defconfig build target (supported since v2017.09).
Use the sun50i-a64-olinuxino.dtb device-tree binary.
Tips, Tricks, Caveats
The board will automatically fallback to FEL mode when there is no SPL header present on neither eMMC nor the SPI NOR flash and when there is no SD card present.
SPI NOR flash
The A64 OLinuXino board does have a footprint to solder a SPI NOR flash package on. The W25Q128FVSIG is a 128 Mbit SPI NOR Flash chip that is cheap, easy to source and the correct package for this footprint on the PCB. Soldering it on should be relatively easy. First clean the footprint with solder wick to make it flat. However, the A64 OLinuXino board may already come with a SPI NOR Flash. For instance, one of the sample boards came with an Eon EN25Q64 as shown below:
=> sf probe SF: Detected en25q64 with page size 256 Bytes, erase size 4 KiB, total 8 MiB
Adding a serial port
There already is a clearly marked UART0 connector that can be identified by the "DBG_UART1" text next to it. All you have to do is attach some leads according to our UART howto.
- A64-OLinuXino-1G with 1GB RAM, no Flash, no WiFi/BLE
- A64-OLinuXino-1Ge16GW with 1GB RAM, 16GB eMMC and WiFi/BLE
- A64-OLinuXino-1Ge4GW with 1GB RAM, 4GB eMMC and WiFi/BLE
- A64-OLinuXino-1Gs16M with 1GB RAM, 16MB SPI flash, no eMMC or WiFi/BLE
- A64-OLinuXino-2Ge8G-IND with 2GB RAM, 8GB eMMC with industrial grade components (-40 to +85°C temperature range)