Megafeis a08

From linux-sunxi.org
Jump to: navigation, search
Megafeis a08
Device front.jpg
Manufacturer Megafeis
Dimensions widthmm x breadth'mm x heightmm
Release Date July 2013
Website Product Page
Specifications
SoC A10s @ 1Ghz
DRAM 512MiB DDR3 @ 432MHz
NAND 4GB
Power DC 5V @ 1.5A
Features
Video HDMI (Type A - male)
Audio HDMI, SPDIF
Network WiFi 802.11 b/g/n (Realtek device)
Storage µSD
USB 1 USB2.0 Host, 1 USB2.0 OTG

This page needs to be properly filled according to the New Device Howto and the New Device Page guide.

Identification

In android, under Settings->About Tablet, you will find:

  • Model Number: SoftwinnerEvb
  • Kernel-Version: 3.0.8 [email protected] #6 Mon Dec 10:44:01 CST 2012
  • Build Number: elite_nm307_v11-eng 4.0.4 IMMQ76D 20121210 test-keys

Incidentally, that's the same android image that is running on the Semitime g2.

Sunxi support

Current status

Supported.

Images

HW-Pack

BSP

Manual build

  • For building u-boot, use the "Megafeis_A08" target.
  • The .fex file can be found in sunxi-boards as megafeis_a08.fex

Everything else is the same as the manual build howto.

Tips, Tricks, Caveats

FEL mode

The is a UBoot button which triggers FEL mode. You can reach it through a hole in the case, left, about in the middle of the top cover of the device.

Adding a serial port (voids warranty)

DEVICE UART pads

Device disassembly

If necessary, provide a short description of how to open the device. Perhaps explain how the pins can be most easily popped.

Locating the UART

Describe how to find the RX,TX,GND signals here, and mention the UART howto.

There are 3 obvious pads below the SoC. Two of them are bound to be RX and TX. See the UART howto for more information on determining which is which, and how to solder on some wires.

Pictures

Take some pictures of your device, upload them, and add them here.

Also known as

See also

  • Semitime_g2: Different board, different exterior, but it has the same android identification strings.