MarsBoard A10

From linux-sunxi.org
Jump to: navigation, search
MarsBoard A10
Marsboard A10 front.JPG
Manufacturer HAOYU Electronics
Dimensions 80mm x 55mm x 20mm
Release Date March 2013
Website www.marsboard.com
Specifications
SoC A10 @ 1Ghz
DRAM 1GiB DDR3 @ 480MHz
NAND 4GB
Power DC 5V @ 2A
Features
Video HDMI (Type C - mini)
Audio 3.5mm headphone plug, HDMI
Network 10/100Mbps Ethernet (Realtek RTL8201CP)
Storage µSD, SATA
USB 2 USB2.0 Host, 1 USB2.0 OTG

This page needs to be properly filled according to the New Device Howto and the New Device Page guide.

The MarsBoard was a short-lived credit-card sized, extendable board with an Allwinner A10 SoC.

Identification

The board reads "www.MarsBoard.com" on top, and has an A10 SoC clearly visible.

Sunxi support

Current status

Supported.

Images

HW-Pack

BSP

Manual build

You can build things for yourself by following our Manual build howto and by choosing from the configurations available below.

U-Boot

Sunxi/Legacy U-Boot

Use the Marsboard_A10 build target.

Upstream/Mainline U-Boot

Use the Marsboard_A10 target for building mainline U-Boot.

Linux Kernel

Sunxi/Legacy Kernel

Use the marsboard_a10.fex file.

Upstream/Mainline kernel

Use the sun4i-a10-marsboard.dtb device-tree binary for the mainline kernel.

Tips, Tricks, Caveats

FEL mode

The single button near SATA port triggers FEL mode.

JTAG

This page explains how to attach JTAG to your marsboard.

Expansion Headers

Board have 2 x 70 pin expansion headers.

Adding a serial port

Marsboard A10 UART pads

On the P2 header, pins 64, 65 and 66 are ground, TX and RX, respectively. Attach some 2.0mm pitch leads according to our UART howto.

Pictures

Also known as

See also

Manufacturer images

Index of /marsboard