Langcent h6s

From linux-sunxi.org
Jump to: navigation, search
Langcent h6s
H6SB-hd12-a20-front.jpg
Manufacturer Langcent
Dimensions 150mm x 93mm x 23mm
Release Date October 2013
Website H6S product page
Specifications
SoC A20 @ 1Ghz
DRAM 512MiB DDR3 @ 360MHz
NAND 4GB
Power DC 5V @ 2A
Features
Video HDMI (Type A), 3.5mm AV connector
Audio 3.5mm AV connector, HDMI, SPDIF
Network WiFi 802.11 b/g/n (Realtek RTL8188EUS), 10/100Mbps Ethernet (Realtek RTL8201CP)
Storage SD
USB 3 USB2.0 Host

This page needs to be properly filled according to the New Device Howto and the New Device Page guide.

Identification

Find out the strings as reported under settings.

In android, under Settings->About Tablet, you will find:

  • Model Number: DEVICE
  • Build Number: SOC_BOARD_DEVICE_*.*

Sunxi support

Current status

Supported.

Images

HW-Pack

BSP

Manual build

  • For building u-boot, use the "Langcent_H6S_config" target.
  • The .fex file can be found in sunxi-boards as hd12-a20-v1.fex

Everything else is the same as the manual build howto.

Tips, Tricks, Caveats

FEL mode

VERIFY ME: There is a button between DC-IN and SPDIF connectors that might trigger FEL mode.

Adding a serial port (voids warranty)

UART and JTAG pads

Device disassembly

There are no screws, only clips. Just turn the device upside down and push your plastic tool between bottom and top cover.

Locating the UART

There are RX and TX pads between the flash chip and the SoC. Just solder on some wires according to the UART howto.

Pictures

Also known as

See also