|Dimensions||267mm x 164mm x 14mm (680g)|
|Release Date||December 2011|
|Website||Rebadger Product Page|
|SoC||A10 @ 1Ghz|
|DRAM||512MiB DDR3 @ 432MHz|
|Power||DC 5V @ 2A, 5000mAh 3.7V Li-Ion battery|
|LCD||1024x600 (10" 10:6)|
|Touchscreen||5-finger capacitive (2x Focaltech FT5301)|
|Video||HDMI (Type C - mini)|
|Audio||3.5mm headphone plug, HDMI, internal speaker, internal microphone|
|Network||WiFi 802.11 b/g/n (Realtek RTL8188CTV)|
|USB||1 USB2.0 Host, 1 USB2.0 OTG|
|Camera||0.3MP (640x480) front|
In android, under Settings->About Tablet, you will find...
Point of View Protab2 XXL
- Model Number: TAB-Protab2XXL(4)
- Kernel Version: 3.0.8+ [email protected] #7
- Build Number: 01F2-D1-H1-H01-1703.20120301
- Model Number: PC1007
- Baseband Version: inet1.0_20
- Kernel Version: 3.0.8+ [email protected] #5 Mon Dec 17 20:39:56 CST 2012
- Build Number: 01F2-D1-H1-H01-1744-20121217
sunxi-boards support is still missing. TODO: add info about the fex and dts files that were added in September 2015
- For building u-boot, use the "PoV_ProTab2_XXL" target.
- The .fex file can be found in sunxi-boards as MANUFACTURER_DEVICE.fex
Everything else is the same as the manual build howto.
Tips, Tricks, Caveats
There is a button between power connector and Mini USB connector which triggers FEL mode.
FT5X touchscreen issues
To make ft5x touchscreen work with X you need to recompile ft5x_ts module as described at Rhombus Tech after commenting out CONFIG_FT5X0X_MULTITOUCH in drivers/input/touchscreen/ft5x_ts.h.
The module is availabe for kernel 3.0.39+ here: 
The screen dimensions and axes will be confused. You will need to change your script.bin as described at eLinux.org like following:
ctp_screen_max_x = 600 ctp_screen_max_y = 1024
Axes can then be swapped with the Debian package xinput by running:
xinput set-prop ft5x_ts "Evdev Axes Swap" 1
Adding a serial port (voids warranty)
By removing the two screws on the connector side, the device is trivially opened.
Locating the UART
There are some clearly marked UART pads in the top left corner of the board, all you need to do is solder on some wires according to our UART howto.
Take some pictures of your device, upload them, and add them here.
Also known as
Add some nice to have links here. This includes related devices, and external links.