|Manufacturer||Auxtek (link missing)|
|Dimensions||90mm x 29mm x 16mm|
|Release Date||September 2012|
|SoC||A10s @ 1Ghz|
|DRAM||512MB DDR3 @ 432MHz|
|Power||DC 5V @ 2A|
|Network||WiFi 802.11 b/g/n (Unknown module)|
|USB||1 USB2.0 Host, 1 USB2.0 OTG|
- 1 Identification
- 2 Sunxi support
- 3 Tips, Tricks, Caveats
- 4 Adding a serial port (voids warranty)
- 5 Pictures
- 6 Also known as
- 7 See also
On the back of the board, XW-MINIPC-I9 is printed.
In android, under Settings->About Tablet, you will find:
- Model Number: I9
- Kernel Version 3.0.8+ [email protected] #9 Thu Dec 13 12:07:24 CST 2012
- Build Number: elite_evb-eng 4.0.4 IMM76D 20121213 test-keys
Supported, apart from the unidentified wifi.
- For building u-boot, use the "Auxtek-T004" target.
- The .fex file can be found in sunxi-boards as auxtek-t004.fex
Everything else is the same as the manual build howto.
Use the sun5i-a10s-auxtek-t004.dts device-tree file for the mainline kernel.
Tips, Tricks, Caveats
The button marked uboot, right next to the serial port, triggers FEL mode.
The wifi chip, marked W01 TOC9002 1237 still is a bit of a puzzler. Perhaps powering the USB bus and then running lsusb will reveal what's in there.
For building the kernel set the options:
- EARLY_PRINTK enabled
- SW_DEBUG_UART configured to 0
Pass earlyprintk on your bootargs.
Adding a serial port (voids warranty)
With a plastic tool it is very easy to remove the top lid How exactly?.
Locating the UART
There are two pads between the SoC and the u-boot button. Just solder on some wires according to our UART howto.